packaging, transport and storage of
The cement attached to chipboard has created a new perfect material for
light building, with high sound isolation and good mechanical properties
is a panel of related materials and pressed with very high compression
ratios to cold, it is derived from: pine wood fibers of measuring
calibrated all amalgamated with the addition of hydraulic binders
(Portland cement) and harmless chemical additives used in mixing methods
MAIN PROPERTIES OF
The building planks
combines the advantageous features of the cement with the
characteristics of wood.
The structure of the table is always made from chipboard and wood chips
that form the top layer on both sides, until a layer of rough in the
The surfaces of the edges are smooth, with a gray color when the product
does not undergo processing of grinding.
table has a lighter color than traditional building materials.
resistant to climate change and frost. Insects
and fungi are not able to attack or damage.Due
to its physical and mechanical characteristics, the product is regarded
as one of the best materials for lightweight construction.
The product is packed in the factory on resistant wood timbers or
pallets of solid wood.
A sheet of material plastico it's positioned as superior protection,
while the base of the pallet is made from raw chipboard.
Stacks are connected by iron strapping or plastic ciklostrip.
The edge of the table under the ciklostrip comes from supports.
Total weight of a pallet, in approximate measure, it is 3200-3500 kg.
totale di una pallett, in misura approssimativa, è di 3200-3500 kg.
(7050 - 7710 lbs.)
Delivery of goods is done by truck.
Despite the load is carried out on behalf of Alberto La Rosa, it is
recommended that the addressee has its own equipment suitable to
download the goods.
Additional transport and movements must be regulated and organized by
it's correct to place the boards on top of
each other on a square wooden beams. To
avoid bending, should be established intermediaries supports. The
total length of the boards must be supported by wooden beams
positioned in at least four points with uniform distance.
The maximum distance between the timber must be 800 mm.
When handling individual
building board, place them on your board. (Figure
The pile should be well covered with cloth or paper to avoid dust
The stack must also avoid the formation of
moisture from the soil.
Avoid storage of the tables on the edge. Figure
2 shows the appropriate methods and incorrect storage of
spent part of the stack, the table of protection should be
rearranged and replaced by a ballast to cover the pile and prevent
the distortion of the tables above.
Avoid storing the tables on the usual
Avoid exposure to direct construction of the
tables with the rays of the sun during the filing
mechanical and manual management of
Appropriate and wrong filing
Technical properties of
of residual moisture conditioning: 6-12%
Inclination force (flexion) : min. 9,0 N/mm (q)
force perpendicular to the table: min. 0,5 N/mm (q)
force inclination : 1 stc. : 4500 N/mm (q)
22ndc. : 4000 N/mm (q)
: 1,5% 24 ore bagnato
change of lenght and width due
to the moisture : max. 0,3% con temperatura
Sup. 20° C umid. 25% a
coefficient of thermal expansion : 10-5/K
thermal conduction : 0,26 W/mK
of resistance vapor
air permeability: 0,133 l/, im m(q) Mpa
no visible changes
acoustic isolation: 30 dB
on 12 mm boards
Ph value in surface*: 11